Publicidad
Idiomas disponibles
Idiomas disponibles
HOW
TO USE PRESSURE
WASHER
If you have any problems operating your pressure washer,
please caltthe pressure washer helptine at
1-888-61 1-6708,
To Start
Pressure
Washer
To start your pressure washer for the first time, follow these
instrecdons st_p-by-step.This starting information also applies if
you have let the pressure washer sit idte for at ieast a day.
I,
2,
,
4.
Place pressure washer near an outside water source
capable of supplying water at a flow rate greater than
3,0 galions per minute and no less than 20 PSI at
pressure washer end of garden hose.
Check that high pressure hose is tightly connected to
spray gun and pump, See"Preparing PressureWasher
For Use" for illustrations.
Make sure unit is in a level position,
Connect garden hose to water inlet on pressure
washer pump, Turn ON water,
CAUTION
5,
6.
Attach nozzle extension to spray gun (Figure 7).
Tighten by hand.
7,
Position nozzle in low pressure mode (slide nozzle
forward)
and squeeze trigger on spr_ gun to relieve
pressure caused by turning ON water.Water
wilt flow
out of gun in a thin stream. Continue
to hold trigger
until there is a steady stream of water and no air
remains in system. Release trigger,
8.
Engage safety latch to spray gun trigger (Figure 8).
, Latch
9,
Start engine according to instructions
given in engine
owner's manual,
NOTE:
If the recoil starter is hard to pull, it may be
instruction will voidwarranty,
nezessar/to
squeeze thegun trigger to relieve internal
pump pressure.
Squeeze trigger on gun until you have a steady stream
of water.This
pur_es the pump of air and impurities.
_
_,11Ti#'%kl
pulled
and _nginefails t o start
Publicidad
