EINHELL SB 701 Manual De Instrucciones página 7

Anleitung SB 701-12 sprachig
1. Technical data
Drilling capacity
Drilling depth
Scroll chuck
Spindle taper
Reach
Pillar diameter
Table
Table adjustment
Table angle adjustment
Useful area/base plate
Motor speed
Motor rating
Speed
Electrical features
Standing area
Overall dimensions
Weight
Packed dimensions
Sound pressure level LPA
Sound power level LWA
2. Product liability / Warranty
All work and uses which are not listed require written
approval from Einhell.
To maintain your rights under the warranty and in the
interest of product safety, please observe the safety
regulations.
If you wish to assert any warranty claims, contact
your dealer.
Warranty repairs are always carried out by us or by
Einhell-authorized service centres. When the
warranty period is over, repairs may also be carried
out by other suitably specialized companies.
09.11.2001 8:22 Uhr
max. 16 mm diameter
60 mm
3-16 mm diameter/B 16
MK 2
126 mm
60 mm
200 x 195 mm
infinitely variable
90/0/90 degrees infinitely
variable
170 x 160 mm
n : 1400 rpm
0
550 watts - S2 15 min.
410 - 2700 rpm
no-volt tripping
touch-sensitive switch
335 x 230 mm
830 x 515 x 320 mm
35,5 kg
765 x 430 x 260 mm
80 dB/A)
90.6 dB(A)
Seite 7
3. Items supplied
Scroll chuck of diameter 3-16 mm/B16 with
chuck key
Shank MK 2/B 16
Knock-out wedge
Assembly tool
Hinged chip guard
Operating instructions
4. Proper use
The SB 701 is a pillar drill with V-belt drive for
twelve different speed settings. Holes of up to 16
mm diameter can be drilled in vertical direction.
To use the pillar drill properly you must observe
the operating, maintenance and repair
instructions as well as the safety regulations
found in this manual.
The SB 701 is to be used only by persons who
are acquainted with the machine. All the
pertinent accident prevention regulations are to
be observed.
Unauthorized modifications to the machine
release the manufacturer from all liability for any
damage caused as the result.
For design reasons it is impossible to eliminate
all residual risks, namely:
1. Reaching into the chuck and drill when in use
2. Cutting yourself on sharp drill bits
3. Chips being flung out during drilling
4. Clothes becoming caught up in the machine
5. Safety regulations
Wear safety items when drilling.
Always keep long hair suitably covered.
Caution! Long hair gets caught easily in
rotating tools.
Always clamp workpieces with suitable additional
tools.
Check the clamping action of the chuck regularly.
Use only suitable additional tools to extract the
drilling chips.
Caution: Never remove chips with your hand.
Never make adjustments or perform any other
operations on the machine when it is running.
Always use the supplied chuck key to open and
close the scroll chuck.
Caution: Always remove the chuck key after use.
The use of the machine is governed by VDE
guidelines, DIN guidelines and the accident
prevention regulations published by professional
associations.
GB
7