Powering Up Light Source; Lamp Life Hours Display; Cleaning; Disinfection - Cuda Fiberoptics XLS-180 Manual De Uso

6.1 POWERING UP THE LIGHT SOURCE
To operate the light source: Attach the instrument or headlamp to the light
source. Turn on the power switch. The fan will start. The indicator on power
switch will light.
6.2 LIGHT BRIGHTNESS DISPLAY AND CONTROL
The light brightness adjustment enables the user to obtain a brighter or darker
illumination of the object of observation.
Adjust the light intensity by turning the intensity control knob.

6.3 LAMP LIFE HOURS DISPLAY

The hour meter shows the total elapsed running time of the unit. Record the
hours when replacing the lamp.

7. CLEANING

NOTE Always disconnect the power cord before cleaning.
The light source can be cleaned with any cleaning agents, which are used for
external cleaning of electric equipment, according to instructions given by the
manufacturer of the cleaning solution.
Do not allow excessive moisture or liquids to come in direct contact with the
light source.
Do not use cleaning agents that are not permitted for use with plastics, i.e.,
ammonia, acetone, salty acids (HCl), etc.
Do not allow cleaning agents or liquids to enter the control unit outlets.

8. DISINFECTION

8.1 DISINFECTING THE LIGHT SOURCE
NOTE Always disconnect the power cord before cleaning.
Use any disinfectant agents which are commonly applied while disinfecting
surfaces of electric medical equipment. Such disinfectant agents usually arrive
in the form of sprays or damp cloths.
Follow the instructions given by the manufacturer of the disinfectant solution.
LIT034CUDA
(English)
Rev. K
Page 9 of 60