Display Ups/Power Conditions; Enable/Disable Alarm; Self-Test - Tripp-Lite ECO-UPS Serie Manual De Propietario

Basic Operation

Display UPS/Power Conditions

On-Line AC Power Mode LCD Data
The LCD screen offers 7 screens of UPS and site power information as the UPS is operating in on-line power mode. To advance to the next
screen, press the button. The screens are displayed in this order:
1. INPUT VOLTAGE
5. ESTIMATED RUNTIME
Battery Power Mode LCD Data
The LCD screen offers 7 screens of UPS and site power information as the UPS is operating in battery power mode. When the UPS switches
to BATTERY MODE, the UPS will automatically switch to report ESTIMATED RUNTIME. To advance to the next screen, press the
screens are displayed in this order:
1. INPUT VOLTAGE
5. ESTIMATED RUNTIME

Enable/Disable Alarm

To temporarily mute the alarm while the unit is in battery mode, press and hold the mute button
screen to indicate that the alarm has been temporarily muted.
Note: The low battery alarm will still sound even if the battery alarm is temporarily muted.

Self-Test

Press and hold the power button
the capacity with a load. Upon completion of the test, UPS will return to line mode. If test fails, the replace icon
will sound. If this occurs, charge the batteries for 12 hours and repeat the self-test. If there is another failure, contact Tripp Lite for battery
replacement options. Connected equipment can remain on during the test. Do not unplug your UPS; this will remove safe electrical grounding.
2. INPUT FREQUENCY
6. OUTPUT VOLTAGE
2. INPUT FREQUENCY
6. OUTPUT VOLTAGE
to initiate the test. The test will last approximately 10 seconds as the UPS switches to battery to test
3. OUTPUT kW
7. OUTPUT FREQUENCY
3. OUTPUT kW
7. OUTPUT FREQUENCY
6
4. OUTPUT kVA
button. The
4. OUTPUT kVA
until the icon flashes on the LCD
will display and an alarm