Sinvest VGE Blue Lagoon UV-C Tech Serie Manual Del Usario página 6

BLUE LAGOON UV-C TECH
OPERATION
EN
In the Blue Lagoon UV-C Tech, a UV-C radiation with a wavelength of 253.7 nm is generated by the
special UV-C lamp, ensuring a lethal effect on bacteria, viruses and moulds (including Legionella
bacteria and Cryptosporidium). The Blue Lagoon UV-C Tech will ensure that your pool water is clean,
fresh and clear in an efficient and environmentally-friendly manner. The water is led through the
UV-C device via a pump. The UV-C radiation neutralises bacteria, viruses and other microorganisms
and stops them from multiplying. The Blue Lagoon UV-C Tech has a built-in electronic ballast. This
ballast ensures optimum performance of the lamp. In addition, the stainless steel interior of the
reactor ensures the reflection of the UV-C rays, thereby increasing the efficiency up to 35%. Thanks
to the Blue Lagoon UV-C Tech, your swimming pool water will be disinfected efficiently and safely,
and the quality of your water will remain excellent.
* The Blue Lagoon 130 watt amalgam lamp is not affected by temperature fluctuations in the water
and generates a constant, powerful radiation.
INSTALLATION OF THE EARTH (DRAWING 1)
1. Pull the cable (2) through the strain relief (4) before fitting the synthetic strain relief (4) onto the earth
bolt (1). Position the strain relief (4) at approximately 10 cm from the eye (2) of the earth cable.
2. Place the eye (2) of the cable onto the earth bolt that is fitted to the housing.
3. Then place a toothed lock washer (3).
4. Fit the strain relief (4), creating a loop of Ø5 cm.
5. Finally place the second toothed lock washer (5) and the lock nut (6) onto the earth bolt.
6. Once the parts have been placed onto the earth bolt in the correct sequence, they can be
tightened with a spanner or a ring spanner number 8.
INSTALLATION OF THE UV-C DEVICE (DRAWING 2)
Determine where the device will be installed. The Blue Lagoon UV-C Tech must never be installed
behind the Ph regulator or the salt electrolysis system in your swimming pool installation. The
ideal location to install your device is immediately behind the filter. The installation must always
take place outside of the pool. Ensure that there is always water flowing through the unit when the
lamp is on. Never install the unit in an area exposed to full sunlight. The installation must always
take place in a dry and well-ventilated area. The device must be fitted in the vertical position, and
a space of 30 cm must be available underneath to carry out maintenance. An area of approx. 1.5 m
must be available at the top in order to be able to replace the lamp (K) smoothly without having to
dismantle the complete device.
1. Unscrew the screw ring (N) from the housing (U). Remove the UV-C lamp (K) from the supplied
case (see packaging) and carefully slide the lamp into the quartz glass (M). Carefully connect the
white lamp holder (L) to the UV-C lamp (K) and then screw the screw ring (N) hand-tight onto
the housing (U).
6 | BLUE LAGOON UV-C TECH
Please read through these instructions for use
carefully before installing this device.