Tripp-Lite PDUMH15AT Manual Del Propietário página 24

2. Instalación
Configure la Interfaz de la Red en Modo Terminal: Después de una breve pausa, debe
aparecer una página de inicio en el programa de emulación de terminal. Oprima cualquier tecla
del teclado en 5 segundos para cambiar los parámetros. Si transcurrieron los 5 segundos, reinicie
la interfaz de red. Para reiniciar, use un clip para papel pequeño o una herramienta con punta para
oprimir el botón de restaurar ubicado sobre el puerto de red RJ45 (consulte el aviso
sección 3. Características para la ubicación del botón de restaurar).
La siguiente secuencia de arranque se mostrará en la ventana de la terminal:
BSP Version 12.06.xxxx.xxxxx built on [date] [time] by SYSTEM
Copyright Tripp Lite 2008-2016, All rights reserved.
...
booting flat image
PLATFORM: trippliteSnmpCard9210_H_16_32 16M/32M
------------------------------------------------------------------------------
NETWORK INTERFACE PARAMETERS:
FQDN poweralert-0610337151181
The board will obtain IPv4 configuration parameters from the network.
DHCPv6 is enabled on LAN
DNS server is 8.8.8.8
Time is supplied by SNTP at an interval of 360 minutes
Primary SNTP Server host is 0.pool.ntp.org
Secondary SNTP Server host is 1.pool.ntp.org
Time zone is set to -6:00 from GMT, DST Enabled
SERVICES:
FTP is enabled on port 21
HTTP is enabled on port 80
HTTPS is enabled on port 443
SSH is enabled on port 22
SSH is enabled on port 2112
TELNET is enabled on port 23
TELNET is enabled on port 5214
SNMP is enabled on port 161
SYSLOG is disabled
HARDWARE PARAMETERS:
Serial channels will use a baud rate of 9600
RTC date and time in GMT: 07/25/2016 19:00:23
This board's serial number is 2422AY016757C00899
This board's Ethernet MAC Address is 00:06:67:25:97:B5
This board's SNMP engine boot count is 7 (0)
After board is reset, start-up code will wait 5 seconds
------------------------------------------------------------------------------
Press any key in 5 seconds to change these settings. Enter any character within
5 seconds to interrupt the boot sequence
Press A to Accept the settings, or M to Modify? m
Enter the root password: ********* The default root password is TrippLite
Reset configuration and root password to default values?
For each of the following questions, you can press <Return> to select the value
shown in braces, or you can enter a new value.
ETHERNET INTERFACE SETTINGS:
Obtain IPv4 settings automatically using DHCP for Ethernet interface [Y]? N
IP address [192.168.1.176]? Enter the desired static IP here
Subnet mask [255.255.255.0]? Enter the Subnet mask
Gateway address [192.168.1.1]? Enter the Gateway address
16-05-185-9335E0.indb 24
24
en la
7F
7/28/2016 3:04:52 PM