Cycle Programming; Automated System Test - Genius SPRINT 382 Manual Del Usuario

ADVANCED PROGRAMMING
Display Function
ASSISTANCE REQUEST (combined with next fun-
ction):
If activated, at the end of countdown (settable
with the next function i.e. "Cycle programming")
it effects 2 sec. of pre-flashing (in addition to the
AS
value already set with the PF function) at every
Open pulse (job request). Can be useful for setting
scheduled maintenance jobs.
Y
= Active
no
= Disabled

CYCLE PROGRAMMING:

For setting countdown of system operation cycles.
Settable (in thousands) from
cycles.
nc
The displayed value is updated as cycles pro-
ceed.
This function can be used to check use of the
board or to exploit the "Assistance request".
GATE STATUS:
St
Exit from programming and return to gate status
viewing (see Chpt 5.1.).
To reset the programming default settings, check if the edge input
is opened (SAFE LED OFF), and simultaneously press keys +, - and F,
holding them down for 5 seconds.
Modification of programming parameters comes into effect imme-
diately, whereas definitive memory storage occurs only when you
exit programming and return to gate status viewing. If the equipment
is powered down before return to status viewing, all modifications
will be lost.
6. START-UP
6.1. INPUTS CHECK
The table below shows the status of the LEDs in relation to to the status of
the inputs.
Note the following: Led lighted = closed contact
Led off = open contact
Check the status of the LEDs as per Table.
The status of the LEDs while the gate is closed at rest are shown in
bold.
dl = -3
= Right-hand opening movement
LEDS LIGHTED
FCA Limit-switch free
FCC Limit-switch free
OPEN B Command activated
OPEN A Command activated
FSW OP Safety devices disengaged Safety devices engaged
FSW CL Safety devices disengaged Safety devices engaged
STOP Command inactive
EDGE Safety devices disengaged Safety devices engaged
dl = 3-
= Left-hand opening movement
LEDS LIGHTED
FCA Limit-switch free
FCC Limit-switch free
OPEN B Command activated
OPEN A Command activated
Safety devices disengaged Safety devices engaged
FSW OP
FSW CL Safety devices disengaged Safety devices engaged
STOP Command inactive
EDGE Safety devices disengaged Safety devices engaged

7. AUTOMATED SYSTEM TEST

When you have finished programming, check if the system is operating
correctly.
Most important of all, check if the force is adequately adjusted and if the
safety devices are operating correctly.
+
F +
Default
no
00 99
to thousand
00
OFF
Limit-switch engaged
Limit-switch engaged
Command inactive
Command inactive
Command activated
OFF
Limit-switch engaged
Limit-switch engaged
Command inactive
Command inactive
Command activated
17