Session Time - Kinetec CPM concept Manual De Empleo

This function, MODULATION Mode is a way to set within the tolerance of a patient at the beginning of a session.
Set up the patient and proceed as below:
Beginning
Switch the unit ON
To select the MODULATION Mode
To select the Modulation level
( key + for flexion, key - for extension)
To select the Modulation level when reached,
immediately press
To start the session with the new movement limits
Comment: arrived at the limit max (-10° or 135°) the angle max is automatically recorded and exit of the function.
This function, The BY-PASS MODE is a way to address the pain threshold of a patient during a session.
IMPORTANT: Can be used only when the machine RUN
Beginning
The unit is running
To select the BYPASS mode
To select the new discomfort level
To select the new discomfort level when reached,
immediately press
Continue the session with the new movement limits
Comment: This function is not available during the warm Up cycles.
Arrived at the limit max (-10° or 135°) the angle max is automatically recorded and exit of the function.
This function shows the running time (in minutes) of the session (motor functioning).
• It directly accessible by the key
This counter is reset each time the unit is switched ON.
How to define the patient tolerance • At the start of a session
Keys to press
ELBOW MODULE 1.0
ELBOW MODULE
10
Or
10
MODUL.: use + oR -
10
Or
MODUL.: use + oR -
10 manual
Continuous press
MODUL.: use + oR -
Or
7 manual
Elbow module
7
.
Keys to press
Elbow module
7 RUN
BYPASS: use + oR -
7
Or BYPASS: use + oR -
-5 bypass
Continuous press
BYPASS: use + oR -
Or
-5 bypass
Elbow module
-5
, the display shows
TIME
30
Display
KINETEC
Please wait
STOP 0 90
Warm up
STOP 0 90
STOP 0 90
0 90
7 50
RUN 10 55
How to define the patient tolerance • During the session
Display
10 55
run 10 55
-5 55
10 70
RUN 50 70
02h25
STOP 15 90
Use of the hand control
Remarks
If the Warm Up mode is selected, switch
OFF this mode by pressing on the key.
Check if the hand control is not locked (see
page 6)
The display indicates the keys to be used to
drive the machine; this message is
displayed 3 seconds.
The unit is moving to the selected way.
It is waiting for you to select new limits.
The new limit of the movement is recorded
The angle display changes with current
movement.
Remarks
Check if the hand control is not locked
(See page 6).
The display indicates the keys used to run
the machine.
This message is displayed 3 seconds.
The unit is moving to the selected way.
It is waiting for you to select new limits.
The new limit of the movement is recorded.
The angle display changes with current
movement.

Session Time

13
GB