Allmatic NC4 Serie Manual De Instrucciones página 65

ALLMATIC
3. Insert screws and tighten with 30 Nm (for NC4 - 125) and 60 Nm (for NC4 - 160).
Fig. 24: NC4 - 125 Jaw installation
4. Clamping force is achieved by turning the crank in clockwise direction.
5. Move jaws forwards until they make slight contact. Align them with a rubber hammer.
6. Completely clamp NC4.
Fig. 25: NC4 - 125 Jaw installation
7. Fully tighten all screws.
Pre-tightening torque (Nm)
Tightening torque (Nm)
NC4
NC4 125
30
75
Operation | 9
EN
160
60
120
65 / 376