Step 1 Measure Cabinet Opening - Monogram ZWE23E Instrucciones De Instalación

WARNING
Under certain
circumstances, this
refrigerator can tip forward.
Injury to persons can result.
Install Anti-Tip Bracket packed with this refrigerator.

STEP 1 MEASURE CABINET OPENING

AVAILABLE VS. REFRIGERATOR
WIDTH
Measure width of cabinet opening where refrigerator
will be placed, W.
Be sure to account for any countertop overhang,
baseboard thickness and any clearance desired.
Width, W, should not be less than 36 inches. The
refrigerator will be placed approximately in the
middle of this opening.
Rear Wall
W
REFRIGERATOR
Front
Installation Instructions
Baseboard
Thickness
or Countertop
Overhang
(Whichever
is Greater) Plus
Any Desired
Clearance
RH Side
6
STEP 2 LOCATE ANTI-TIP BRACKET
A. Place the anti-tip floor bracket locator template
(included inside the anti-tip kit) onto the floor up
against the rear wall, within W, and in line with the
desired location of the RH side of the refrigerator
(see Figure 1).
Figure 1 – Installation Overview
Floor – Concrete
(2 Holes)
Floor – Wood
(2 Holes)
B. Place the anti-tip floor bracket onto the locator
template with its RH floor holes lined up with
the floor holes indicated on the template sheet,
approximately 15-1/4" from the edge of the sheet or
the RH side of the refrigerator.
C. Hold down in position and use the anti-tip floor
bracket as a template for marking the holes based
upon your configuration and type of construction
as shown in Step 3. Mark the hole locations with a
pencil, nail or awl.
NOTE:
It is REQUIRED to use at least 2 screws to
mount the floor bracket (one on each side of the
anti-tip floor bracket). Both must be into either the
wall or the floor. Figure 2 indicates all the acceptable
mounting configurations for screws. Identify the
screw holes on the anti-tip floor bracket for your
configuration.
2 Wall Holes
Floor Bracket
to Install
RH Holes
15 ¼"
Rear RH
Corner of
Cabinet Wall
RH Side of
Locator Template
Refrigerator
Sheet