Step 3 Install The Refrigerator; Important; Step 4 Remove The Freezer Drawer; Step 5 Remove The Fresh Food Doors - Monogram ZWE23E Instrucciones De Instalación

STEP 3 INSTALL THE REFRIGERATOR

BEFORE MOVING REFRIGERATOR
INDOORS

IMPORTANT:

the installation location require a 31-1/4" min. opening.
If the opening is less than 31-1/4", the top cap, doors
and drawers must be removed. (See steps 4–6.)
NOTE: Skip steps 4–5 if door removal is not required.
Go to page 9, Move The Refrigerator.
NOTE: To prevent damage, leave inside
packaging, door spacer and outside
protective wrap in place until the unit
is moved to the installation location.

STEP 4 REMOVE THE FREEZER DRAWER

The freezer drawer can be removed, if needed, to fit
through tight areas.
Read these instructions completely and carefully.
A. Pull the freezer door open to full extension.
B. Remove 3 attachment screws, located at the bottom on each
side of the freezer door using 3/8" hex socket driver.
CAUTION
Lifting Hazard
Freezer door is heavy Use both hands to secure the door
before lifting.
Lift the freezer door to disengage it from the slide
C.
mechanism. The door can safely rest on the bottom.
Do not rest the door on any other surfaces to avoid
scratches. Push the slide mechanism back completely
until it self retracts.
Installation Instructions
Doors and passageways into
STEP 5 REMOVE THE FRESH
FOOD DOORS
A. Securely tape the door shut with masking tape or
have a second person support the door.
B. Start with left-hand door first: Remove the hinge
cover on top of the left refrigerator door by removing
all hex screws and pulling it up. Do the same for the
right-hand door and the middle cover.
C. Disconnect both electrical connectors at the top cover.
Remove the 1/4" hex head screw to disconnect the
ground wire from the hinge.
Remove the 1/4" hex head screw to remove the
strain relief from the water line.
Ground
screw
8
Hinge
Cover
Strain
Relief