Rear Panel - Peavey Transtube Serie Manual De Instrucciones

Each preset, factory or user, has primary and secondary settings for gain/EQ, modulation, delay and
reverb. These primary and secondary settings do not include amp model, modulation type or delay
tempo changes. You can access and edit these settings by placing the PFC 4 footswitch in the EFX
Select Mode. That's a multitude of effects/gain combinations. EFX Select Mode is discussed in detail
on page 13.
Important!
Now that you have a good understanding of the preset structure it is important that you keep three
things in mind while editing and saving presets.
First, you can change any preset (user or factory) and save it to any of the 16 USER preset
locations. For example, you may change the Pre Gain level on factory preset A1 and save it to user
preset B3. Of course, when you pull up factory preset A1 the Pre Gain value will revert back to its
original value and the new value will be stored in the user preset B3. Once changed, the original
user settings will no longer be identical to the factory settings.
Second, whenever you reinitialize the Transformer you perform a hard reset. All programmed
presets will be deleted and the Transformer will revert back to its original factory and user settings.
Third, every preset has primary and secondary settings accessible by the EFX Select footswitch
mode.
AC POWER
There are two features that deal with AC power on the Transformer. Both are located on the left,
rear panel of the unit. Next to these features you will find the proper AC line voltage requirement for
your particular amplifier. It is important that this requirement be met for your unit's safe and proper
use. Refer to the diagram below for the location of these parts.

REAR PANEL

2
1. REMOVABLE AC POWER CORD (UNDERSIDE OF REAR CHASSIS)
This receptacle is for the IEC line cord (included), which provides AC power to the unit.
Connect the line cord to this connector and to a properly grounded AC supply. Damage to
the equipment may occur if an improper line voltage is used. (See voltage marking on unit.)
Never remove or cut the ground pin of the line cord plug. This unit is supplied with a properly
rated line cord. When lost or damaged, replace this cord with one of the proper ratings.
2. POWER SWITCH
Place this switch in the "ON" position to turn the Transformer on. The LEDs on the front
panel and the footswitch (if connected) will illuminate indicating that the unit is on.
6