Language Selection; Electrical Wiring; Mains Connection; Battery Connection - Detnov CAD-150-8 Manual Del Instalador

2- Installation Guide
The panel's controls are designed to be easy to customize the language. In the
languages sheet attached to this manual, you will find the entries for Spanish, English,
Italian and Portuguese. Select the required language and insert the card into the slot
located at the bottom of the keyboard. The locations are marked with the letters A, B
and C.
GB
It is recommended that the equipment is powered and tested before connecting
devices such as sensors, manual call points etc. The panel must be connected via an
external circuit breaker using a 1.5 mm
To avoid crossing the network, the mains cable must be separated from the
communication bus lines. If the system can be affected by an electrical disturbance,
we recommend the use of a ferrite tube as close as possible to the connection.
It is essential to use the holes marked on the box. Use a drill bit to drill the box and
insert the cable glands.
It is advisable to use a shielded cable. Connect the cable shield to the corresponding
terminals (insulating the screen to prevent short circuits) and ensure that the facility
has an approved mains Earth.
Always disconnect the mains power before handling the panel.
Always connect the mains first and then the batteries.
Make the Earth cable longer so that in case of abrupt removal it is the last to disconnect.
Insert the wire into the plastic guide tabs using the plastic case, to prevent the wire
coming loose in the case of sudden removal.
Never use the fuses to connect and disconnect the mains power, use the external
circuit breaker.
The panel requires two 12V 7Ah batteries. The batteries must be connected in series
for the proper functioning of the panel.

2.1- Language Selection

2.2- Electrical wiring

cable section. The voltage should be 230VAC.
2
2.3- Power up the panel

2.4- Mains connection

2.5- Battery connection

6