Craftsman 124.34983 Manual Del Proprietário página 6

CARTON CONTENTS
UNPACKING AND CHECKING CONTENTS
Carefully unpack the Drill Press and all its parts, and compare against the illus-
tration following.
WARNING:
• To avoid injury from unexpected starting, do not plug the power cord into a
power source receptacle during unpacking and assembly. This cord must
remain unplugged whenever you are assembling or adjusting the drill press.
• If any part is missing or damaged, do not plug the drill press in until the miss
ing or damaged part is replaced, and assembly is complete.
• To protect the drill press from moisture, a protective coating has been applied
to the machined surfaces.
Remove this coating with a soft cloth moistened with kerosene.
WARNING: To avoid fire or toxic reaction, never use gasoline, naphtha, acetone,
lacquer thinner or similar highly volatile solvents to clean the drill press.
TABLE OF LOOSE PARTS
Unpack carton, check you machine to see parts listed below:
A. Main parts:
See Fig. 1
1. Head assembly
2. Column Assembly
3. Table
4. Base
5. ON/OFF Switch
6. Flexible Lamp
To turn on drill press, lift paddle switch from bottom.
To turn off drill press, push paddle switch down.
To prevent unauthorized use, remove the center key from the
switch. Figure IB and 1C
°\
3
Drill press cannot be turned ON if key is not inserted.
FIGURE 1
FIGURE 1B FIGURE 1C