Preliminary Operations; Choosing Place Of Installation - Novovent Domestic Serie Manual De Instrucciones

with any other type of risk that may occur to the unit. For example, risks derived from the entrance of
foreign bodies, or risks due to the presence of flammable or toxic gas.

Preliminary operations

• Check the perfect condition of the various components of the unit.
• Control that contained within the packing, there are the installation accessories, and documentation.
• Transport the packed section as close as is possible to the intended place of installation.
• Do not place tools or weight on top of the packed unit.
• Once that the unit is installed, check that the impeller turns free of friction.

Choosing place of installation

• Do not position the unit in an area in which flammable gases, acidic or corrosive substances are pre-
sent. They may damage various components in an irreparable manner.
• Do not place the equipment where it is exposed to splashing water or liquids. Make sure no water enter
from the outside in case of rain.
• The room to install must be clean, free of suspended solid particles, corrosive chemicals and / or
flammable or explosive. Please request information on available units suitable for these applica-
tions.
• Exhaust air must not be sent by pipeline used for removing fumes from equipment powered by gas or
other fuel. The exhaust duct should be used for its exclusive use or directly extract air outside.
• Do not use in hazardous environments, such as gasoline vapors, alcohol, or when using products that
release flammable gases and aerosols.
• Provide a minimum clearance of 700 mm on each side, depending on the size of the fan. This will
facilitate the installation and maintenance tasks.
IMPORTANT:
For the perfect operation of the units, the installation must made under the norms UNE
100-230-95 any other configuration may reduce the performance, life time or destroy the
fan. Lack of observation of this indications of the unit may cause the withdrawal of the
warranty.
N.B: For more information about this norm UNE 100-230-95 you can contact with NOVOVENT agents.
IMPORTANT:
It is forbidden to operate the equipment without the protection elements included in the unit
(such as grids).
For wall, glass or roof installation you must:
• Open the front cover by loosening the screw.
• To fix it use the circular holes of the base that can be used as a template. Drill the holes in the wall with
5 mm drill bit and anchor the fan to the wall using screws.
In the case of equipment designed to be inserted in ducts:
• Ducts should be sized according to the installation and the characteristics of the fan.
Air duct connections and wall mounting
10