Publicidad
Idiomas disponibles
Idiomas disponibles
SYMPTOM
Saw stops or will not start
Excessive vibration
Cannot make square cut
when crosscutting
Blade stalls (however, motor turns)
Blade does not come up to speed
Cut binds, burns or stalls when ripping
Cut not true at 45 ° or 90 ° positions
Tilt and elevating handwheel
difficult to turn
Rip fence binds on guide tube
Frequent opening of fuses or
circuit breakers
Material kicked back from blade
POSSIBLE
CAUSE(S)
1. Overload tripped
2. Saw unplugged from wall or motor
3. Fuse blown or circuit breaker tripped
4. Cord damaged
1. Stand on uneven floor
2. Damaged saw blade
3. Bad drive V-belt
4. Bent pulley
5. Improper motor mounting
6. Loose hardware
7. Loose set screw in pulley
Miter gauge not adjusted properly
1. Drive belt not tight
2. Drive belt worn
1. Extension cord too long or wire gauge
too small
2. Low shop voltage
3. Motor not wired for correct voltage
1. Dull blade with improper tooth set
2. Blade is binding at one end of cut
(heeling)
3. Warped board
4. Rip fence not parallel to blade
5. Riving knife/splitter out of alignment
6. Excessive feed rate
Positive stops not properly adjusted
1. Sawdust on rack and worm gears
2. Bushing collars too tight
3. Bushings and bearing surfaces dirty
1. Guide rails or extension wing not
properly installed
2. Guide of rip fence not adjusted
properly
1. Motor overloaded
2. Fuses or circuit breakers do not have
sufficient capacity
1. Rip fence out of alignment
2. Riving knife/splitter not aligned with
blade
3. Feeding stock without rip fence
4. Splitter not in place
5. Dull blade
6. Letting go of material before it is past
blade
7. Anti-kickback fingers dull
CORRECTIVE
ACTION
1. Allow motor to cool and reset by
pushing reset switch
2. Check all plug connections
3. Replace fuse or reset circuit breaker
4. Replace cord
1. Reposition on flat, level surface
2. Replace saw blade
3. Replace drive V-belt
4. Replace pulley
5. Check and adjust motor
6. Tighten hardware
7. Tighten set screw
Adjust miter gauge
1. Adjust drive belt tension
2. Replace drive belt
1. Replace with adequate size cord
2. Contact your local electric company
3. Refer to motor junction box
1. Sharpen or replace blade
2. Adjust table and rip fence
parallel to blade
3. Make sure concave or hollow side is
facing down; feed slowly
4. Adjust rip fence
5. Adjust riving knife/splitter to fall in
line with blade
6. Reduce feed rate
Adjust blade tilt
1. Clean and relubricate
2. Adjust properly
3. Clean thoroughly and lubricate
1. Reassemble guide rails
2. Adjust guides
1. Feed work slower into blade
2. Install proper size fuses or circuit
breakers
1. Align rip fence with miter slot
2. Align riving knife/splitter with blade
3. Always use rip fence or miter gauge
4. Install splitter or riving knife
5. Replace blade
6. Push material all the way past blade
before releasing work
7. Replace or sharpen anti-kickback
fingers
16
Publicidad
