Dimplex 26 SLIMLINE FIREBOX Manual De Instrucciones página 6

Remote Control - See Fig.2
The maximum range of use is ~ 5metres.
NOTE: It takes time for the receiver to respond to the
transmitter.
NOTE: The reciever for the remote control is located in
the display, aim the remote control in this direction when
inputting commands.
Do not press the buttons more than once within two seconds
for correct operation.
Battery Information - See Fig. 2
1. To activate the remote control remove the clear battery
isolation strip at the base of the remote control, which is used
to ensure your remote control reaches you fully charged.
2. To replace the remote control battery, turn over the
remote control, and follow the diagram embossed on the
remote control
3. Only use CR2025 or CR2032 size of batteries.
Fitting- See Fig. 3 & 4
IMPORTANT: If not using a Dimplex mantel, the fireplace must
be installed in an enclosure with the following MINIMUM
dimensions(Figure 3).
The firebox must be secured in place, using the L-Brackets
supplied with this product, to fit these brackets please follow
the steps shown in Fig. 4.
1. Select a suitable location that is not susceptible to
moisture and is at least 1 meter away from drapes, furniture
and high traffic.
2. Store the fireplace in a safe,
dry and dust free location.
3. Clearance for air circulation beneath the fireplace
is provided by two spacers. DO NOT INSTALL FIREPLACE
DIRECTLY ON CARPET OR SIMILAR SURFACES WHICH MAY
RESTRICT AIR CIRCULATION. If installing the fireplace in
a carpeted area, place a one-piece, solid flat surface
under the fireplace. Ensure that all feet rest securely on
this surface!
4. In some jurisdictions this appliance is supplied without
a plug this is to comply with the local regulations. In such
instances this appliance must be installed by a suitabily
quailified installer and the means for disconnection must
be incorporated in the fixed wiring in accordance with
the local wiring rules.
New Wall Construction
1. Select a suitable location that is not susceptible to
moisture and is away from drapes, furniture and high
traffic.
2. Place the fireplace in the desired location to see how
it will look in the room.
3. Mark the desired location on the floor.
4. Use studs to frame an opening as per Fig. 3.
Option #1
The power cord can be run from behind the trim and
along the wall to an outlet near the fireplace.
Option #2
A new outlet can be installed inside the framing
construction. Plug the fireplace into a 10-13Amp/230-
240 Volt outlet. If the cord does not reach you may use
a 3-core type extension cord rated for a minimum of
10 Amps.
Existing Fireplace
1. Seal all drafts and vents with a non-fibrous insulation
material to prevent any chimney debris from falling
onto the fireplace. Do not install into an existing
fireplace that is prone to dampness.
2. Cap the top of the chimney flue to prevent rain from
entering.
3. Plan your electric power supply.
4. The power cord can run along
the front of the hearth to an
outlet near the fireplace.
Installing Front Glass- See Fig. 5,6 & 7
NOTE: The outer glass is shipped seperate to the firebox.
1. Remove the three screws holding the side trim as shown
in Fig. 5. and remove the metal trim.
2. Unpack the glass, ensure it is free from dust and finger
marks and slide in to position as shown in Fig. 6.
3. Position the metal trim removed in step 1, and secure
with the three screws as per Fig. 7