Exhaust Filter - Kenmore 116.36822 Manual Del Propietário

Check the motor filter frequently and clean
when dirty.
WARNING
Electrical Shock Hazard
Do not operate the cleaner without the
motor safety filter. Be sure the filter is
dry and properly installed to prevent
motor failure and/or electrical shock.
Always unplug power cord from electri-
cal outlet before performing any service
on vacuum.
Remove the dust cover and dust bag.
If the filter, located in the bottom of the dust
bag cavity is dirty, remove it by pulling for-
ward out from under the ribs.
Motor
Safety
Filter
Wash the foam filter in warm soapy water,
rinse and dry thoroughly by squeezing the
filter in your hand and letting it air dry.
DO NOT wash in the dishwasher.
DO NOT install damp.
Replace the foam filter by sliding it back
into place under the ribs in the dust bag
cavity.
Electrical Shock Hazard
Unplug power cord from electrical out-
let. Do not operate the vacuum cleaner
without the primary or exhaust filters.
Be sure the filters are properly installed
to prevent motor failure and/or electri-
cal shock.
EXHAUST FILTER
The exhaust filter must be replaced when
dirty. It should be replaced regularly
depending on use conditions.
The filter CANNOT be washed as it will
lose its dust trapping ability.
NOTE: See PARTS AND FEATURES
for the exhaust filter number.
1. Remove dust
cover.
2, Remove the
exhaust filter
cartridge.
_3. Insertnew
Exhaust
exhaust filter
Filter__'_"_ cartridge.
Push only on filter
cartridge frame, not
on filter material
itself.
4. Replace dust cover.
13