\
Hose
Wands
Identify each ofthe attachments shown
above.
When using attachments,
be careful
not to overextend the stretch hose
when reaching. Trying to reach
beyond the hose stretch
capability
could cause the vacuum
cleaner to ti
over.
Attachments
used in dirty areas, such
as under refrigerator, should not be
used on other surfaces until they are
washed. They could leave marks.
Electrical Shock And Personal Injury
Hazard
Disconnect electrical supply before ser-
vicing or cleaning the unit. Failure to do
so could result in electrical shock or
personal injury from cleaner suddenly
starting.
TO USE ATTACHMENTS
Remove the lower end of the stretch hose
from the cleaner by grasping the hose col-
lar, twisting and pulling straight out. The
attachments can now be added to the hose.
Note: The motor protector may open
when using attachments
or when cleaning
new carpet, due to reduced airflow by the
attachments themselves or by new carpet
fuzz filling the dust bag quickly. See the
TROUBLESHOOTING
section.
The attachments will fit on the hose or the
wand. In addition, the dusting brush will
also fit on the crevice tool.
The hose can be pulled off the wand by
grasping the cuff and twisting while pulling
up.
The attachments can be added to the hose
if the item to be cleaned is not far from the
vacuum cleaner.
NOTE: When cleaner is turned on, the hose
will have a tendency to collapse due to
suction of the vacuum cleaner.
If more reach is needed:
Crevice
Teol
Wand
An extra wand, without tabs, is included.
This extra wand can be added to the wand
with tabs for extra reach. Insert wand and
twist a quarter of a turn to secure fit.
If the dusting brush/combination brush is
being used and more reach is needed, the
crevice tool can be added to the wand, then
the dusting brush can be added to the
crevice tool.
TO STORE ATTACHMENTS
Return the hose to its position on the wand
and the attachments to their holders.