INSTALLATION
REQUIREMENTS
Tools and Parts
IMPORTANT:
Observe all governing codes and ordinances.
Installer: Leave Installation Instructions with the
homeowner.
Homeowner: Keep Installation Instructions for future
reference. Save these Installation Instructions for the local
electrical inspector's use.
Keep cardboard shipping piece or plywood under
refrigerator until it is installed in the operating position.
Comply with installation specifications and dimensions.
Remove any moldings or decorative panels that prevent
the refrigerator from being serviced.
Contact a qualified electrical installer.
Order factory panels, make custom panels, or consult a
qualified cabinet maker or carpenter to make panels.
Tools needed:
Make sure that you have the tools necessary for proper
installation:
Hand drill or electric drill
(properly grounded)
Drill bits
Two adjustable wrenches
Phillips screwdriver
Parts needed:
Your refrigerator dealer has a kit available with a ¹⁄₄ in.
(6.35 mm) saddle-type shutoff valve, a union, and copper
tubing
¹⁄₄ in. (6.35 mm) copper tubing with shutoff valve
¹⁄₄ in. (6.35 mm) compression fitting
6 - #8 x 3 in. (7.6 cm) wood screws (longer screws may be
needed)
1 or 2 - 2 in. x 4 in. x 32 in. (5 cm x 10 cm x 81 cm) wood
board(s)
Custom panels (provided by homeowner)
4
⁷⁄₁₆ in. and ¹⁄₂ in. open-end
wrenches
¹⁄₄ in. nut driver
⁵⁄₃₂ in. Allen wrench
⁵⁄₁₆ in. socket wrench
Product Dimensions
Side View (All models)
1
2
24"
(61 cm)
83
1
/
"
8
(211 cm)*
3
1. 25 ¹⁄₈ in. (64 cm) dimension is to front of top grille
2. Power cord (24 in. [61 cm])
3. 5 ft. (1.5 m) water line tubing taped to back
) Dimensions shown are for leg levelers extended ¹⁄₈ in.
*
NOTE: (
(3 mm) below rollers. For levelers fully extended 1¹⁄₄ in. (32 mm)
below rollers, add 1¹⁄₈ in. (29 mm) to this dimension.
Top View (All models)
Model
36 in. (91 cm)
42 in. (106 cm)
48 in. (122 cm)
25
1
/
"
8
(64 cm)
23
1
/
"
2
(60 cm)
3
1
/
" (9 cm)*
2
A
25
1
/
"
8
(64 cm)
Width A
35 in. (89 cm)
41 in. (104 cm)
47 in. (119 cm)