KitchenAid KSSC48QKS00 Instrucciones De Instalación página 5

Front View for Side by Side Models
NOTE: Width dimensions shown represent distance from outside
trim to outside trim.
A
(see chart following)
Width of Refrigerator:
Model
36 in. (91 cm)
42 in. (106 cm)
48 in. (122 cm)
83 1 / "
8
(211 cm)
Width A (as shown above)
36¹⁄₄ in. (92 cm)
42¹⁄₄ in. (107 cm)
48¹⁄₄ in. (123 cm)
Front View for Bottom Mount Models
NOTE: Width dimensions shown represent distance from outside
trim to outside trim.
36 1 / " (92 cm)
4
Opening Dimensions
The built-in refrigerator can be installed into a recessed opening
in the cabinets or at the end of cabinets using a side panel to
enclose the refrigerator side.
NOTE: Installation requires a ¹⁄₂ in. (12.7 mm) clearance to
remove the top grille and for proper airflow.
1
1. A ¹⁄₂ in. (12.7 mm) space is required
Location Preparation:
1. Wall studs must be located on rear wall 80 in. to 90 in.
(203 - 229 cm) above floor.
NOTE: The solid soffit must be within 1 in. (2.5 cm) maximum
above the refrigerator. If the solid soffit is higher than
1 in. (2.5 cm) or one is not available, then the refrigerator
must be braced to prevent tipping during use. See the "Install
Anti-Tip Boards" section.
2. Grounded electrical outlet should be placed in the top
shaded area, 4 in. (10.2 cm) from the right side of the
cabinets or end panel (see the "Electrical Requirements"
section).
1
83 / "
8
(211 cm)*
5