Publicidad
Idiomas disponibles
Idiomas disponibles
Enlaces rápidos
Audi A3 2006-2013
KIT FEATURES
• DIN radio provision with pocket
KIT COMPONENTS
• A) Radio housing • B) Pocket
A
B
WIRING & ANTENNA CONNECTIONS (sold separately)
Wiring Harness: • XSVI-9004-NAV
Antenna Adapter: • 40-EU56 • 40VW54 (Standard Symphony models)
TOOLS REQUIRED
• (2) 86-9001 Radio removal tools • Pry tool
METRA. The World's best kits.
Installation instructions for part 99-9104
99-9104
metraonline.com
™
Table of Contents
Dash Disassembly ..................................................2
Kit Assembly ...........................................................2
CAUTION!
Metra recommends disconnecting the negative bat -
tery terminal before beginning any installation, unless the vehicle
manufacturer recommends against so. Please check with your local
Dealership for more information. All accessories, switches, climate
controls panels, and especially air bag indicator lights must be con -
nected before reconnecting the battery or cycling the ignition. Also,
do not remove the factory radio with the key in the on position, or the
vehicle running. It would be best to remove the key from the ignition
and then wait a few seconds before removing the factory radio.
© COPYRIGHT 2004-2015 METRA ELECTRONICS CORPORATION
Publicidad
Manuales relacionados para Metra 99-9104
Resumen de contenidos para Metra 99-9104
- Página 1 KIT COMPONENTS • A) Radio housing • B) Pocket CAUTION! Metra recommends disconnecting the negative bat - tery terminal before beginning any installation, unless the vehicle manufacturer recommends against so. Please check with your local WIRING & ANTENNA CONNECTIONS (sold separately) Dealership for more information.
-
Página 2: Dash Disassembly
99-9104 Dash Disassembly 1. Insert the long ends of Metra’s 86-9001 radio removal tools (Figure B) into the slots in the LOAD factory radio and pull the radio out. MENU (Figure A) TONE 2. Disconnect the wiring. TAPE SCAN (Figure B) -
Página 3: Kit Assembly
(Figure C) 5. Locate the factory wiring harness and antenna plug in the dash and make all necessary connections to the radio. Metra recommends using the proper mating adapters from Metra and/or AXXESS. 6. Install the assembled kit assembly into dash. -
Página 4: Important
Installation instructions for part 99-9104 IMPORTANT If you are having difficulties with the installation of this product, please call our Tech Support line at 1-800-253-TECH. Before doing so, look over the instructions a second time, and make sure the installation was performed exactly as the instructions are stated. -
Página 5: Características Del Kit
Instrucciones de instalación para la pieza 99-9104 Audi A3 2006-2013 Indice 99-9104 Desmontaje tablero ..........2 Ensamble del kit .............2 CARACTERÍSTICAS DEL KIT • Provisión de radio DIN con cavidad COMPONENTES DEL KIT • A) Carcasa del radio • B) Cavidad ¡PRECAUCIÓN! -
Página 6: Desmontaje Tablero
99-9104 Desmontaje tablero 1. Inserte los extremos largos de las herramientas de remoción de radio 86-9001 de Metra (Figura B) en las LOAD ranuras del radio de fábrica y jale MENU el radio para sacarlo. (Figura A) TONE 2. Desconecte el cableado. -
Página 7: Ensamble Del Kit
Metra recomienda que use adaptadores adecuados de acoplamiento de Metra y/o de AXXESS. Vuelva a conectar la terminal negativa de la batería y pruebe el radio para verificar que funcione correctamente . -
Página 8: Importante
Instrucciones de instalación para la pieza 99-9104 IMPORTANTE Si tiene dificultades con la instalación de este producto, llame a nuestra línea de soporte técnico al 1-800-253-TECH. Antes de hacerlo, revise las instrucciones por segunda vez y asegúrese de que la instalación se haya realizado exactamente...