Iso Mount Radio Provision With Pocket - Metra 99-8209 Instrucciones De Instalación

ISO mount radio provision with pocket

1. Slide the Mounting Brackets onto the
sides of the Radio Housing until the side
clips engage. (Figure A)
Note: Use Bracket Set 1 for xA, xB, and
tC Use Bracket Set 2 for the 2008 xB
and xD.
2. For Bracket Set 1 cut and remove all
mounting tabs except the tabs being
used for your application. (Figure B)
Note: Tabs are marked xA, xB and tC.
For Bracket Set 2 skip to step 3.
3. Mount the ISO Brackets to the radio
u sing the screws supplied with the
radio. (Figure C)
4. Slide the aftermarket radio into the
c age until it snaps into place. (Figure D)
5. Snap the Trim Plate onto the front of the
R adio Housing. (Figure D)
6. Locate the factory wiring harness in the
dash. Metra recommends using the
proper mating adapter from Metra or
AXXESS. Re-connect the negative
battery terminal and test the unit for
proper operation.
7. Reassemble dash in reverse order
of disassembly.
Kit Assembly 99-8209
9
(Figure A)
Bracket Set 1
(Figure B)
(Figure C)
(Figure D)
side clips