Iso Din Head Unit Provision - Metra 99-3033 Instrucciones De Instalación

ISO DIN head unit provision

1. Mount the ISO Brackets to the head unit
with the screws supplied with the unit.
(Figure A)
2. Slide the head unit into the radio
opening until the side clips engage.
3. Snap the Trim plate into the
Radio Housing.
4. Locate the factory wiring harness in the
dash. Metra recommends using the
proper mating adapter from Metra or
AXXESS. Re-connect the negative
battery terminal and test the unit for
proper operation.
5. Reassemble dash in reverse order
of disassembly.
6. Mount the support plate assembly to
the sub-dash with (4) hex-head screws
previously removed on page 1. (Be sure
the rear support bullet engages the rear
support bracket in the dash). (Figure B)
Kit Assembly 99-3033
6
(Figure A)
(Figure B)