Publicidad
Idiomas disponibles
Idiomas disponibles
Enlaces rápidos
Installation instructions for part 99-3017B
Chevrolet Trax 2015-up
KIT FEATURES
• ISO DIN radio provision with pocket
• Painted to match factory finish
KIT COMPONENTS
• A) Radio trim panel • B) Radio brackets • C) Pocket • D) (4) #8 x 3/8" Phillips screws
A
B
WIRING & ANTENNA CONNECTIONS (sold separately)
Wiring Harness: • LC-GMRC-044 or AX-ADBOX2 and AX-ADGM04
Antenna Adapter: • 40-EU55
METRA. The World's best kits.
99-3017B
C
metraonline.com
™
Dash Disassembly ................................................. 2
Kit Assembly
– ISO DIN radio provision with pocket ...................... 3
TOOLS REQUIRED
• Panel removal tool • Phillips screwdriver
• Socket wrench
D
CAUTION: Metra recommends disconnecting the negative battery
terminal before beginning any installation, unless the vehicle
manufacturer recommends against so. Please check with your
local Dealership for more information. All accessories, switches,
climate controls panels, and especially air bag indicator lights
must be connected before reconnecting the battery or cycling
the ignition. Also, do not remove the factory radio with the key
in the on position, or the vehicle running. It would be best to
remove the key from the ignition and then wait a few seconds
before removing the factory radio.
© COPYRIGHT 2015 METRA ELECTRONICS CORPORATION
Table of Contents
Publicidad
Manuales relacionados para Metra 99-3017B
Resumen de contenidos para Metra 99-3017B
- Página 1 • A) Radio trim panel • B) Radio brackets • C) Pocket • D) (4) #8 x 3/8” Phillips screws • Socket wrench CAUTION: Metra recommends disconnecting the negative battery terminal before beginning any installation, unless the vehicle manufacturer recommends against so. Please check with your local Dealership for more information.
-
Página 2: Dash Disassembly
(Figure D) Note: Remember the process when removing these pockets as you will need to reinstall them into the 99-3017B radio panel the same way. Continue to kit assembly (Figure B) (Figure D) -
Página 3: Kit Assembly
Metra recommends using the proper 2. Attach the (9) metal panel clips to mating adapter from Metra and/or the 99-3017B radio trim panel. AXXESS. Re-connect the negative 3. Attach the a/c vents to the battery terminal and test the radio 99-3017B radio trim panel with for proper operation. -
Página 4: Important
Log onto www.installerinstitute.com or call 800-354-6782 for more information and take steps toward a better tomorrow. Metra recommends MECP certified technicians METRA. The World’s best kits. metraonline.com ™ © COPYRIGHT 2015 METRA ELECTRONICS CORPORATION... -
Página 5: Chevrolet Trax 2015 Y Mas
• A) Panel de moldura del radio • B) Soportes del radio • C) Cavidad • D) (4) tornillos Phillips #8 de 3/8” • Destornillador Phillips • Llave de tubo PRECAUCIÓN: Metra recomienda desconectar la terminal negativa de la batería antes de iniciar cualquier instalación, a menos que el fabricante del vehículo recomiende lo contrario. -
Página 6: Desmontaje Del Tablero
99-3017 Desmontaje del tablero 1. Desenganche y quite el panel que rodea el radio de fábrica, incluyendo las rejillas del aire acondicionado. (Figura A) 2. Quite los (4) tornillos de 9/32” que sujetan el chasís del radio. (Figura B) 3. Quite los (2) tornillos que sujetan las rejillas de aire acondicionado al panel de la moldura del radio de fábrica y guárdelos para el ensamble del kit. -
Página 7: Ensamble Del Kit
3. Coloque las rejillas del aire de acoplamiento de Metra y/o acondicionado en panel de la de AXXESS. Vuelva a conectar la moldura del radio 99-3017B usando terminal negativa de la batería y la tornillería de fábrica. (Figura A) pruebe el radio para verificar que 4. -
Página 8: Importante
800-354-6782 para obtener más información y avance toward a better tomorrow. hacia un futuro mejor. Metra recomienda técnicos con certificación del Programa de Certificación en Electrónica Móvil (Mobile Electronics Certification Program, MECP). METRA. The World’s best kits. 1-800-221-0932 metraonline.com ™ © COPYRIGHT 2015 METRA ELECTRONICS CORPORATION...