Honda Accord 1994-1997; Honda Accord 1998-2002 - Metra 99-7898 Instrucciones De Instalación

Honda Accord 1994-1997

1. Remove the ashtray and (1) 3/4" #8
Phillips screw exposed. Open the
storage compartment and remove
(2) #8 Phillips screws exposed.
2. Remove the cup holder tray and (3)
#8 Phillips screws inside.
3. Lift the center console out and
remove (2) Phillips screws exposed
at the base of the dash trim bezel.
4. Unclip the bezel and remove.
5. Remove (2) hex head screws
securing the factory radio and
(Figure A)
Dash Disassembly
disconnect the wiring. (Figure A)
6. Cut and remove all of the mounting
clips on the radio housing EXCEPT
clips "A" and "H" (the clips can be
identified by the stamped letter on
the back of the housing, near each
clip). (Figure B)
7. Mount the rear support bracket (R1)
to the back of the radio housing
with (2) #8 x 3/8" Phillips pan head
screws supplied.
Continue to kit assembly
"A"
"H"
"H"
(Figure B)
99-7898

Honda Accord 1998-2002

1. Unsnap the clock panel, disconnect
the wiring and remove. (Figure A)
2. Remove (1) Phillips screw exposed
in the clock cavity.
3. Remove (2) Phillips screws below
the factory radio.
4. Unclip the radio trim bezel and
disconnect the wiring. (Figure A)
5. Remove (4) Phillips screws securing
the factory radio assembly and
disconnect the wiring.
6. Remove (2) screws securing the
(Figure A)
7
factory pocket to the assembly.
7. Cut and remove the mounting clips
from the radio housing.
8. From the mounting brackets cut and
remove tabs "B" (the clips can be
identified by the stamped letter on
the back of the housing, near each
clip). (Figure B)
9. Secure the brackets to the
housing with (4) #8 x 3/8" Phillips
pan head screws.
Continue to kit assembly
"B"
(Figure B)