DJI FPV Guía De Usuario página 4

EN
Disclaimer and Warning
Please read this entire document and all safe and lawful
practices DJI
to read and follow instructions and warnings may
result in serious injury to yourself or others, damage
to your DJI product, or damage to other objects in the
vicinity. By using this product, you hereby signify that
you have read this disclaimer and warning carefully
and that you understand and agree to abide by the
terms and conditions herein. You agree that you are
solely responsible for your own conduct while using this
product, and for any consequences thereof. DJI accepts
no liability for damage, injury or any legal responsibility
incurred directly or indirectly from the use of this product.
DJI is a trademark of SZ DJI TECHNOLOGY CO., LTD.
(abbreviated as "DJI") and its affiliated companies. Names
of products, brands, etc., appearing in this document are
trademarks or registered trademarks of their respective
owner companies. This product and document are
copyrighted by DJI with all rights reserved. No part of this
product or document shall be reproduced in any form
without the prior written consent or authorization of DJI.
This document and all other collateral documents are
subject to change at the sole discretion of DJI. For up to
date product information, visit http://www.dji.com and
click on the product page for this product.
This disclaimer is available in various languages. In the
event of divergence among different versions, the English
version shall prevail.
Introduction
The DJI FPV Drone Arm Bracers are used to increase the
strength of the aircraft arms and reduce damage to the
aircraft in the event of a collision. It is recommended to use
the arm bracers when there are many obstacles around.
Installation
1. Check the mark on the bottom of the arm bracer and
insert the arm bracer marked L from underneath the
frame arms on the left side. Make sure the arm bracer
forms a complete guard around the frame arms.
2. Check the mark on the connector for the arm bracer
and insert the clamp on the connector marked L into
the groove at the end of the arm bracer. After aligning
the screw holes, tighten the screw from the bottom.
3. Repeat the steps above to install the arm bracer on the
right side. The arm bracer and connector are marked R.
Specifications
Weight (one side): 19.5 g
TM provided carefully before use. Failure
3