Threading The Machine - Kenmore 385.15202 Manual De Instrucciones

Threading the Machine
• Threading the machine
* Raise the thread take-up lever to its highest position by
turning the handwheel counterclockwise.
* Raise the presser foot lifter.
* Place a spool on the spool pin, with thread coming off as
shown.
[] Draw the end of thread around the upper thread guide.
[_While holding the thread near the spool, draw the end of
the thread down around the check spnng holder
[] Firmly draw the thread up and from right to left over the
take-up lever then down into the take-up lever eye.
[_ Slide the thread behind the needle bar thread guide or"
the left.
E_Thread the needle from front to back.
• Drawing up bobbin thread
[] Raise the presser foot. Hold the needle thread lightly
with your left hand.
[] Rotate the handwheel counterclockwise, toward you, for
one complete turn. Bring the bobbin thread up by pulling
the needle thread up.
[] Pull both threads 4" to 6" (10.0 to 15.0 cm) under and
behind the presser foot.
f
\% .[]
S
_2;
[]
[]
[]
24