Repairing And Maintenance - Gima OXY-2 Guía De Uso

7 OPERATING GUIDE
7.1 Insert the two batteries properly to the direction, and
then replace the cover.
7.2 Open the clip as shown in Figure 5.
7.3 Let the patient's finger put into the rubber cushions
of the clip (make sure the finger is in the right posi-
tion), and then clip the finger.
7.4 Press the switch button once on front panel.
7.5 Do not shake the finger and keep the patient at ease
during the process. Meanwhile, human body is not
recommended in movement status.
7.6 Get the information directly from screen display.
7.7 In boot-strap state,press button ,and the device is
reset.
Fingernails and the luminescent tube should
be on the same side.

8 REPAIRING AND MAINTENANCE

• Please change the batteries when the low-voltage dis-
played on the screen.
• Please clean the surface of the device before using.
Wipe the device with medical alcohol first, and then let
it dry in air or clean it by dry clean fabric.
• Using the medical alcohol to disinfect the product after
use, prevent from cross infection for next time use.
• Please take out the batteries if the oximeter is not in
use for a long time.
• The best storage environment of the device is -40ºC
to 60ºC ambient temperature and not higher than 95%
relative humidity.
• Users are advised to calibrate the device termly (or ac-
cording to the calibrating program of hospital). It also
can be performed at the state-appointed agent or just
contact us for calibration.
ENGLISH 28