Tabla de contenido
Publicidad
SIGNODE BXT2-32
Fig. 6
1
Fig. 7
AUTO
1
MAN.
+ / -
LOW
AUTO
MAN.
LOW
+ / -
Fig. 8
16
1
– Take the tool in the right hand and lift the rocker lever
(6/1) towards the handle.
– Slide the straps, one on top of the other, into the tool
up to the stop.
The strap lead is now approximately 5 cm (2")
beyond the tool.
– Release the rocker lever (6/1).
Before tensioning ensure that no other
persons are in the danger area!
– Press the tension button (7/1) until the preselected
strap tension is reached. The tool switches over
automatically as soon as the strap tension has
been reached. The straps are welded and the
upper strap cut off. After welding do not
retension.
– The tensioning process can be stopped at any time
and continued again. In order to release the strap
tension after the tensioning process, lift the rocker
lever (6/1) towards the handle (see safety note in
Chapter 5.8).
– The strap tension can be adjusted on the operating
panel (see Chapter 5.5).
Welding without tensioning
To perform welding before the strap has been
tensioned, first switch to operating mode „Manual/Semi-
Automatic". However, the tensioning button must be
pressed once before welding.
– The digital display (8/1) indicates the cooling time of
the sealing. After finishing the friction welding, the
digital display counts backwards (3,2,1). Do not
remove the tool during this time!
Audible signal sounds once:
+
The sealing cycle is finished.
– After the audible signal sounds, raise the rocker lever
up to the handle.
– Swing the tool away from the strapping backwards and
to the right. If the tool is removed too early, the
audible signal will sound several times (poor
sealing quality).
– Check the seal (refer to chapter 5.3).
Never transport or move packaged goods
with incorrectly welded seals.
If the tool is used in a dirty environment, it is
recommended that it should be cleaned daily.
In particular the tension wheel and the tooth plate should
be checked for damage and kept clean. This is best per-
formed by blasting with compressed air (wear goggles).
03.14
Publicidad
Tabla de contenido
