Setting Mode Of Operation - Signode BXT2-32 Manual De Operación, Partes Y Seguridad

SIGNODE BXT2-32
1
3
AUTO
➟
AUTO
MAN.
LOW
6
AUTO
➟
MAN.
LOW
7
9
AUTO
➟
MAN.
LOW
Fig. 14
22
2
AUTO
➟
MAN.
LOW
5
4
+
MAN.
flashing / intermitente /
AUTO
clignote
8
+
1.
MAN.

5.8 SETTING MODE OF OPERATION

– Press „Function" button (14/1) briefly. The digital
display will show „F" (Function). The present mode of
operation is shown.
– Then press the „Mode of operation" button (14/2)
briefly until the desired mode of operation is shown.
Semi-Auto strapping (Standard):
Strapping is performed by pressing the tensioning button
(14/5). When the strap tension is reached, welding and
cutting is performed automatically.
– Press the „Mode of operation" button (14/2). When the
„AUTO" (14/3) and „MAN" (14/4) LED indicators light
continuous green „Semi-Auto" mode of operation is
selected.
Fully-automatic strapping:
Strapping is performed by simultaneously tapping
tensioning button (14/7) and safety button (14/8) (two-
hand operation). Tensioning, welding and cutting are
performed fullyautomatically.
– Press the „Mode of operation" button (14/2). When the
„AUTO" LED indicator (14/6) flashes green „Fully-
Auto" mode of operation is selected.
STOP OF FULLY-AUTO SEQUENCE:
By pressing tension- /welding button (recommended)
or raising rocker lever again.
Frequent operation of the rocker lever with
the strap under tension will lead to increased
wear on the pawl parts (Pos. 59,65/page 34).
Manual strapping (manual welding):
Strapping is performed by first pressing the tensioning
2. 2.
button (1.). When the tension is reached, press the
welding button (2.).
– Press the „Mode of operation" button (14/2). When the
„MAN" LED indicator (14/9) lights continous green
„Manual" mode of operation is selected.
03.14