Digital Load Meter
1
Select Bank Button: This button
can be pressed to show total current for
each bank. Pressing this button once
will display the total current for all of
the Bank 1 outlets, located nearest to
the input cord. The LED for Bank 1
will illuminate and the total Amp current
for Bank 1 outlets will display on the
LED screen
C
a second time will produce the same
results for Bank 2. Pressing the button a
third time will display total PDU current
and both Bank 1 and Bank 2 LEDs will
light. Pressing the button additional
times will repeat the cycle.
If you press and hold this button for
four seconds, the numbers in the LED
Amps display
versatility. The unit can be mounted with
the power cord facing the top or bottom
while still being able to read the display.
2
Select Outlet Button: This button
individual outlet. The LED located next to the selected outlet and the LED for the Bank
to which the outlet belongs (
displayed (in amps) on the LED screen
the same results for outlet 2, pressing a third time for outlet 3 and so on through all the
outlets.
If you press and hold this button
to the unit in the LED screen
"no address" will display, one letter at a time. If there is an IP Address programmed, the
address will display 1 digit at a time with dashes (-) representing dots or periods (.).
Features
IEC-60320-C13
IEC-60320-C19
16-10-211-933668.indb 8
A
D
. Pressing this button
A
will flip for mounting
C
can be pressed to show the current for each
B
or
) will flash when the total current for that outlet is
D
E
for 4 seconds you can display the IP Address assigned
B
. The default is no address assigned. If this is the case,
C
Outlets: During normal operation, the outlets distribute AC power to
connected equipment.
NEMA 5-15/20R
Outlet LED: Once the unit is powered-on, each outlet individually ramps
up and each outlet LED will illuminate when the associated outlet is ready
to distribute live AC power.
D
B
UP
DOWN
. Pressing this button a second time will produce
C
8
C
E
A
12/22/2016 11:36:18 AM