Initial Use - auna Silver Star CD-DAB Manual De Uso

EN
20

INITIAL USE

Before operation
• Before operation, please make sure that VOLTAGE mentioned on the
power supply is same as the voltage of your local area.
• Use the supplied mains adaptor to connect the device to a household
mains socket.
Basic operation-getting started
1. Connect the mains adaptor to the DC jack, fully extend the telescopic
antenna, plug in and switch on at the mains.
2. The display backlight will illuminate for a few seconds, a welcome
message "Welcome to Digital Radio" will appear in the display briefly
and the clock(00:00:00) will flash in the display. The DAB mode will
automatically be selected and the first time the radio is connected to
the supply the radio will perform a quick scan. The display will show
'Scanning' a slide bar that indicates the progress of the scan, the name
of the last station found and the total number of stations found so far.
3. When the scan is finished the radio will play the first alphanumerically
found station. If the radio does not find any stations, 'No DAB Station'
displayed.
4. Adjust the volume to the desired level using the VOL(+/-) knob.
5. Press the Previous or Next buttons / to scroll through the located
stations. Once the station of choice is located, press the Enter knob to
select the station.
6. To switch your radio between DAB, FM, BT, CD, USB and Aux in mode,
press Mode button repeatedly.
7. Press and hold the Power/Mode button will go into 'Standby' mode
Using the radio- DAB mode
DAB differs from analogue radio; the separate signals from a number of
stations are grouped together and transmitted as a single frequency. These
groups are referred to as multiplexes and ensembles. Each time a group has
been found the name of the group will be shown on the lower half of the
display