Make Measurement; Spo Measurement - Gima OXY 110 Guía De Uso

45

3 Make Measurement

3.1 SpO Measurement
2
Operation procedures:
1. Connect the SpO
ked with "SpO
head of the connector firmly and pull).
2. The red blinking light inside the clip of the SpO
connection.
3. Insert one finger (index finger is preferred, the nail should be not too long) into
the clip of the probe according to the finger mark,as shown in figure 3.1.
4. The device will begin to take the measurement, and the measured result will be
displayed on the screen, as shown in figure 4.2.
Figure 3.1 demonstration for SpO
Safety instructions for SpO
 Long term use of the SpO
or pain, especially for those with microcirculatory problems. It is recommended
that the probe should NOT be applied to the same place for over two hours,
change the measurement site periodically and when necessary.
 When the ambient temperature is over 35°C, please change the measuring site
every two hours; when the ambient temperature is over 37°C, please do NOT
use the SpO
2
 Do NOT place the SpO
 Do NOT put the SpO
blood pressure measurement may affect the SpO
 The device is calibrated to display functional oxygen saturation.
 Do NOT allow the sensor cable to twist or bend.
 Check the SpO
sensor.
 When the temperature of the SpO
 Remove nail polish or other cosmetic products from the fingernail.
 The fingernail should be of normal length.
probe to the connector on the upper-side of the device mar-
2
". (Note: When disconnecting the connector, be sure to hold the
2
probe
2
measurement
2
probe on the same place may result in discomfort
2
sensor, as using in high temperatures can cause burns.
probe on a finger with edema or fragile tissue.
2
probe and pressure cuff on the same limb, otherwise the
2
sensor and cable before use. Do NOT use a damaged SpO
2
ENGLISH
probe indicates a successful
2
2
sensor is abnormal, do not use it further.
2
measurement.
2