Photocell; Fuel Filter; Fuel Filter A In Fuel Tank; Pump Pressure Adjustment - Mi-T-M MH-0600-0M10 Manual Del Operador

PhoToCell

CLEAN PHOTOCELL ANNUALLY OR AS NEEDED.
• Remove upper shell.
• Remove fan (See fan blades).
• Remove photocell from its mounting bracket
• Clean photocell lens with cotton swab.
TO REPLACE: Remove side cover near Operation switch.
• Disconnect wires from Operation switch and remove photocell.
• Disconnect wires from circuit board and remove side cover.
• Install new photocell and attach wires to circuit board.
• Replace switch wires to operation switch and side cover.
• Replace fan and upper shell.

fUel fIlTeR

CLEAN TWICE PER HEATING SEASON OR AS NEEDED.
• Open rear shell.
• Remove filter cover by unscrewing four screws.
• Remove fuel filter from filter cover.
• Wash fuel filter in clean kerosene.
• Replace fuel filter and filter cover.

FUEL FILTER A IN FUEL TANK

• Remove fuel cap.
• Take out fuel filter from fuel tank.
• Wash fuel filter A with clean kerosene.
• Replace fuel filter in fuel tank.
• Replace fuel cap on fuel tank.

PUMP PRessURe aDjUsTMenT

1. Remove rear shell.
2. Remove fuel line A from fuel pump by using wrench.
3. Replace pressure gauge at outlet of fuel pump.
4. Adjust pump pressure by turning pressure adjustment screw
5. Replace pressure gauge at outlet of fuel pump.
6. Adjust pump pressure by turning pressure adjustment screw.
7. Turn relief valve clockwise to increase pressure.
8. Turn relief valve counterclockwise to decrease pressure.
NOTE: Using heater without proper maintenance can cause poor combustion and soot production.
16
MAINTENANCE
Kerosene Portable Heater Manual