Mi-T-M MH-0600-0M10 Manual Del Operador página 17

9. Set pump pressure to 128 PSI by turning screwdriver.
note: Pump pressure gauge is not supplied.
NOTE: Use only original equipment replacement parts. Use of alternate or third
party components will void any warranty and may cause unsafe operating
conditions.
10. Stop heater (See OPERATION in this manual).
11. If accessory pressure gauge is being used, remove pressure gauge.
12. Replace pressure gauge, and plug in end of filter cover.
NOTE: If heater does not ignite when heater is turned on, please turn AIR VENT
SCREW counter clockwise to release air, then turn OpERATION SWITCh back
on.
neveR leave
ConneCTeD To a PoWeR soURCe, oR WhIle ConneCTeD To a fUel soURCe
Kerosene Portable Heater Manual
MAINTENANCE
heaTeR UnaTTenDeD WhIle bURnInG,
17