Legal Information - Fronius Vizor Air/3X Manual De Instrucciones

Ocultar thumbs

página de 64

/ 64
Marcadores

Idiomas disponibles

the different levels until the desired level is reached (Fig. 11).

Replacing the main filter and prefilter: If a filter alarm is output, the prefilter

must be replaced (Fig. 12). Please monitor the time between filter alarms.

This becomes shorter each time the prefilter is replaced. If you have

the impression that the change intervals are too short (this is a personal

impression), it is recommended to replace the main filter and the prefilter

(Fig. 13).

Alarm function

Filter clogging alarm: When the filter clogging alarm is tripped, the LED

shows red. Without action, the flow levels III and II change to one lower.

To replace the prefilter and main filter, press and hold the On/Off button for

2 seconds to turn off the blower filter unit. You can now change the filters.

Battery alarm: When the battery alarm is triggered, the LED shows red. A

beep is emitted every second; you can continue using the device for approx.

30 minutes.

Storage

The blower filter unit system and accessories must be stored in a dry place.

Protect it against sunlight, high temperatures, hydrocarbons and solvent

vapours.

Maintenance

Check the helmet regularly according to the operating instructions. Check

the face seal and the air nozzle for holes, cracks or other damage and make

sure that the parts are correctly positioned on the helmet (see instruction

manual). Do not use the system until all worn or damaged parts have been

replaced.

Maintenance schedule

Activity

Cleaning, disinfection

Visual inspection

Charging the battery

Replace seal between main filter and

blower unit

The manufacturer recommends that the unit be serviced at least once a year

by a from manufacturer qualified service company. When the device is in

storage, the battery must be recharged every 4 months.

Cleaning and disinfection

Clean the blower, air hose and helmet using a cloth moistened with soapy

water. Allow the unit to dry at room temperature. Do not use aggressive

cleaning agents or solvents, alcohol or abrasive cleaning agents. The

mechanical seal is washable (hand wash, do not spin).

Troubleshooting

Blower does not switch on

→ Make sure the battery is inserted correctly.

→ Make sure the battery is fully charged.

Filter alarm is activated even though the pre- and main filters have been

replaced and are correctly installed

→ Internal blower filter unit error

→ Return the blower filter unit system to the nearest dealer.

Battery life is too short

→ Battery defective – Replace battery and dispose of defective battery as

hazardous waste.

→ Charger defective - replace.

Technical data

(We reserve the right to make technical changes.)

Nominal protection

Europe: TH3P classification, (TH2P/TH1P with hard

factor

hat)

Australia: P3 classification

Blower unit

Air flow rates:

Material

PC + ABS

Blower

High-quality, ball-bearing mounted blower motor

Frequency

Always after use

Always before and after use

After each use

Replace if the seal is worn or damaged,

but at least 1x per year

Level 1: min. 170 L/min

Level 2: min. 210 L/min

Level 3: min. 240 L/min

Fuse

Electronic fuse

Battery

Type:

Voltage / capacity:

Charging cycles:

Operating time level 1*

Operating time level 2*

Operating time level 3*

Charging time:

Weight:

Colour:

*min. operating time with new filter at room temperature

Noise level

Max. 70 dB(A)

Warning signals

Audible and visual alarm for low battery, clogged or missing

filter and low airflow

Filter

1x type TH3P R SL

for TH3P system (Europe) / P3 system (Australia)

Air hose

Length:

Diameter:

Weight:

Colour:

Weight

1195g / 42.152 oz (incl. filter and belt, without battery)

Dimensions

LxWxH: 222 x 213 x 92.6 mm

Standards

EN 12941, AS/NZS 1716

Notified body

CE 1024

Scope of delivery/Spare parts (see page I, II, lll, 63)

1 blower filter unit PAPR

2 Main filters TH3P R SL filter for TH3P system (Europe) / P3 system

(Australia)

3 Prefilter

4 Spark arrester

5 Filter cover

6 battery (lithium-ion 48 Wh)

7 PAPR-compatible safety helmet

8 faceseal

9 air hose

10 protective cover for air hose (accessories, not included)

11 sealing set

12 leather belt

Further accessories can be found in the main catalogue or on our website.

Explanation of symbols (see page V)

A Read operating instructions before use

B Do not open with sharp objects

C Fragile content

D Store with this side facing up

E Protect from moisture

F Notified body identification mark (respiratory protection)

G Notified body identification mark (eye protection)

H Contains lithium ions

I Plastic, recyclable

J Recommended storage temperature: 5 C° to +25 C°

K Do not dispose of as domestic waste. Dispose of as hazardous

waste.

Declaration of Conformity

See the Internet address on the penultimate page of this manual.