Akron SEVERE DUTY 3491 Instrucciones De Instalación, Funcionamiento Y Mantenimiento página 6

MECHANICAL MONITOR ATTACHMENT
The Monitor is to be mounted on the waterway with a 2.5" NPT thread orflange connection as provided. The front of the
monitor is shown in Figure 4.
THE ROTATIONAL AND ELEVATION STOPS SET THE BOUNDARIES FOR THE AREA IN WHICH THE MONITOR IS AL-
LOWED TO TRAVEL. The monitor is shipped with the rotation stops at 90° right, and at 90° left. All other positions are
achieved by switching the factory set stops and the plugs in the desired stop location. Both the stops and the plugs
have a 1/2 inch hex head. Refer to Figure 4 to determine which stop location is needed for the desired rotation. The
elevation stop sets the upper limit of the elevation. The monitor is shipped with elevation stops at 90° above horizontal
and 65° below horizontal. All other vertical positions are achieved by switching plugs and stops to the desired locations
as indicated in Figure 4.
FIGURE: 2
Page 4