Solo 425 Manual Del Usario página 7

GB
Congratulations on the purchase of your
new SOLO Sprayer. We thank you for your
wise choice and are confident that you
will be very happy with it.
The use of modern materials in conjunction with SOLO
Know-How over many decades guarantee customer sa-
tisfaction with millions of SOLO machines in all countries
of the world.
2. GENEraL INFOrmaTION
The SOLO Pressure Sprayer is designed for the application
of approved plant protection chemicals in agriculture, hor-
ticulture, viticulture and forestry. All Accident Prevention
Regulations and all generally recognized Safety Precautions
are to be adhered to. Spray solutions other than approved
plant protection materials may only be used if any detri-
mental effect to the machine or harm to persons, animals
and environment can be excluded. For the operator and
possibly the chemical manufacturer to test the material re-
sistance to certain chemicals, the product manufacturer will
provide details of the type of materials used for the Pressure
Sprayer. Any unauthorized modification or changes made
to the Pressure Sprayer will automatically exclude liability
claims against the manufacturer.
3. CHECK LIST FOr COmPLETENESS
1 piece Pressure Sprayer
(assembled with Pressure tube and handle )
1 piece LX-lever
with 2 pieces disc 16,5 x 24 x 1/ 1 piece Screw M8 x 30/
1 piece disc 8,4/ 1 piece nut M8/
1 piece spray tube (complet assembled)
1 piece Tank Lid
1 piece Pressure Tank Plug with O-Ring 16 x 3 (not Model 473)
1 piece Operators Manual
1 piece Hollow Cone Nozzle with Swirl Plate and Gasket
1 pc. each symbolic label for container content: herbicide,
fungicide and insecticide.
NOTE:
Affix the appropriate label to identify the container
content.
PLEASE NOTE:
Never pour different agents at the same time into the
container. Before using a different agent, thoroughly clean
out the container and all parts in contact with the spray
agent, then flush with plenty of water. We recommend the
SOLO horticultural equipment cleaner in 500 ml bottles;
part no. 49 00 600
4. ASSEMBLY
The Sprayer is assembled except for the pump lever
which can be attached to either side.
(discharge hose and lever grip already fitted) 1-off lever
grip (LX lever model). The pressure sprayer is supplied
with fittings for assembly of the lever grip (LX lever) pre-
attached on the left-hand side (facing towards the tank
inscription). If you prefer the lever grip (LX lever) to be
mounted on the opposite side, reposition the safety clips
(a) on the r.h. side.
When fitting the LX lever, the retaining tube (b) of the LX
lever should be facing upwards and back (facing towards
the tank inscription).
To store the device, raise the pump handle (C) of the LX
lever in the retaining tube (b) and suspend the spray
tube in both clips (d). To work the pump handle (c),
lower it again in the retaining tube (b).
- The spray tube is connected to the shut-off valve by
means of screw cap.
5. CORRECT CHOICE OF
- The spray tube is connected to the shut-off valve by
means of screw cap.
- To regulate the output quantity/ droplet size, the spray
pressure can be adjusted in steps from 1-4 bar.
- For the treatment of tall bushes or trees, a brass tree
lance (150cm length) is available as an accessory (part no.
49 00528)
For the treatment of shrubs, bushes and trees (three
dimensional distribution) we recommend the use of the
hollow cone nozzle. For area treatment (two dimensio-
nal distribution) we recommend the use of a flat spray
nozzle.