Select Blower Option, Install Ductwork And Electrical Wiring - Best WPD39M Serie Instrucciones De Instalación

1. SELECT BLOWER OPTION, INSTALL DUCTWORK AND ELECTRICAL WIRING

This range hood is intended for outdoor covered patio or lanai area. As with all electric appliances, this unit must
be protected from the effects of weather.
This range hood is not designed for use with a charcoal grill.
Either an interior or exterior blower or in-line blower may be used with this range hood. It must be installed with blower models P12, ILB11,
EB12 or EB15 only. Other blowers cannot be substituted. (Blowers sold separately).
Plan where and how the ductwork will be installed.
A straight, short duct run will allow the hood to perform most efficiently.
Install proper-sized ductwork, elbows and roof or wall cap for the type of blower you are installing. Connect metal ductwork to cap and work
back towards the hood location. Use 2" metal foil duct tape to seal the joints.
Run 3-wire power supply cable to installation location.
The power cable must be a GFCI protected branch circuit.
For best capture of cooking impurities, the bottom of the hood must be located at a distance of 36" above cooking surface.
R
OOF CAP
10" R
OUND DUCT
O
PTIONAL DECORATIVE
FLUE OR SOFFIT
10" R
OUND ELBOW
16"
TO
18"
TOP OF WOOD
MOUNTING STRIP
36"
MINIMUM ABOVE
COOKING SURFACE
HH0185A
M P12 D I
ODEL UAL NTERIOR
TYPICAL DUCTWORK
W
ALL CAP
10" R
O
PTIONAL DECORATIVE
FLUE OR SOFFIT
10" R
18"
HH0183A
B M
LOWER ODEL
B
CAUTION
WARNING
!
WARNING
!
E
XTERIOR
B
LOWER
OUND DUCT
E
XTERIOR
B
LOWER
OUND ELBOW
16"
TO
TOP OF WOOD
MOUNTING STRIP
36"
MINIMUM ABOVE
COOKING SURFACE
EB12 EB15 E
OR XTERIOR
LOWER TYPICAL DUCTWORK
5
10" R
OUND DUCT
I -
N LINE BLOWER
36"
MINIMUM ABOVE
COOKING SURFACE
HH0184A
M ILB11 I - B
ODEL N LINE
TYPICAL DUCTWORK
R
OOF CAP
W
ALL
CAP
LOWER