Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
16. INSTALL THE BLOWER
Refer to instructions included with blower.
Once the blower is installed, plug the blower cord (A) into the female receptacle and the
power supply cord (B) onto the male connector inside the hood.
Do not plug the two cords into each other.
17. REINSTALL THE PAN
Remove protective plastic film covering pan sides and tape over halogen lamps.
Using a Phillips no. 2 or Robertson no. 2 screwdriver and the retaining screws, reinstall the pan
(previously removed in step 6) inside the hood (shaded part on illustration beside).
18. REINSTALL GREASE DRIP RAIL AND BAFFLE FILTERS
Reinstall grease drip rail (1). The illustration beside shows how to reinsert the
grease drip rail(s) into the range hood.
Remove protective plastic film covering Evolution™ hybrid baffle filters before installing them.
Reinstall Evolution™ hybrid baffle filters on
the hood.
It is recommended to install side filters first
and finish with center one.
1. Insert one end of Evolution™ hybrid baffle
filter into the front channel of the hood.
2. Raise the other end toward the inside of
hood and insert in the grease drip rail of
the hood.
Replacement filters are available from your
dealer. See label inside hood for size and
part number.
(INTERIOR OR EXTERIOR BLOWER)
WARNING
!
CAUTION
CAUTION
1
HD0226
HD0225
- 11 -
A
B
HE0078
R
ETAINING SCREWS LOCATION
HD0224
1
2
Publicidad
Tabla de contenido
