Troubleshooting - Metra 99-5834CH Instrucciones De Instalación

Select Radio screen
• To show which brand radio is "auto detected" to the interface, press the "Autodetect"
button. The radio detected will have a filled in circle. If the incorrect radio is shown, select
the proper radio.
• Following is a list of radio manufacturers that the interface presently acknowledges. Others
may be added at a later date. Universal "2 or 3 wire" radios can show up as any of these
radio manufacturers.
Eclipse (Type 1) † Pioneer/Jensen
Kenwood ‡ Alpine *
Clarion (Type 1) † Visteon
Sony / Dual Valor
JVC
STEERING WHEEL CONTROL SETTINGS
Clarion (Type 2) † Parrot **
Metra OE XITE
Eclipse (Type 2) † Philips
LG JBL
(CONT.)
* Note: If the interface shows an Alpine radio, and you do not have an Alpine radio, that means
the interface does not detect a radio connected it, i.e., an open connection. Verify that the 3.5mm
jack is connected to the correct steering wheel jack/wire in the radio.
** Note: The AX-SWC-PARROT is required (sold separately). Also, the Parrot radio must be
updated to rev. 2.1.4 or higher through www.parrot.com.
† Note: If you have a Clarion radio and the steering wheel controls do not work, change the radio
type to the other Clarion radio type; same for Eclipse.
‡ Note: If you have a Kenwood radio and the touchscreen display shows a JVC radio, change the
radio type to Kenwood.

TROUBLESHOOTING

Resetting the interface
1. With the vehicle running, press the Reset Vehicle Type button mentioned in
System Configuration.
2. Refer to Programming, step 3, from this point.
15
REV. 4/5/2019 INST99-5834CH