Metra 99-5831 Instrucciones De Instalación

Installation instructions for part 99-5831
Ford Transit Connect 2014-up
KIT FEATURES
• ISO DIN radio provision with pocket
• ISO DDIN radio provision
• Passenger airbag indicator
• Painted black (99-5831B) or
charcoal gray and black (99-5831G)
KIT COMPONENTS
• A) Radio trim panel • B) Radio brackets • C) Pocket • D) (4) Panel clips • E) (4) #8 x 3/8" Phillips screws
A
B
WIRING & ANTENNA CONNECTIONS (sold separately)
Wiring Harness: • XSVI-5524-NAV or AX-ADBOX2 & AX-ADFD02 Antenna Adapter: • 40-EU10
METRA. The World's best kits.
(With factory 4.2" display)
99-5831
C D
metraonline.com
™
Dash Disassembly ................................................. 2
Kit Assembly
– ISO DIN radio provision with pocket ...................... 3
– ISO DDIN radio provision ...................................... 3
TOOLS REQUIRED
• Panel removal tool • Phillips screwdriver
• T15 Torx driver • T20 Torx driver
NOTE: This installation kit is intended to be used in
conjunction with an AXXESS radio replacement interface.
Models with steering wheel controls will require an
AXXESS radio replacement interface and the AXXESS
ASWC-1 steering wheel control interface for all features
E
to work properly.
CAUTION: Metra recommends disconnecting the negative battery
terminal before beginning any installation, unless the vehicle
manufacturer recommends against so. Please check with your
local Dealership for more information. All accessories, switches,
climate controls panels, and especially air bag indicator lights
must be connected before reconnecting the battery or cycling
the ignition. Also, do not remove the factory radio with the key
in the on position, or the vehicle running. It would be best to
remove the key from the ignition and then wait a few seconds
before removing the factory radio.
© COPYRIGHT 2016 METRA ELECTRONICS CORPORATION
Table of Contents