Descargar Imprimir esta página

Craftsman 247.240800 Manual Del Operador página 11

Publicidad

Idiomas disponibles

Idiomas disponibles

6.
Slide the hinge pin into the hole located on the mounting tab, as in Figure
11. Use the cut-out window (See inset in Figure 11) to line up the hinge pin
on the other side and push pin all the way in until it reaches the end-stop. At
this point the pin clips into place and is secured by a tab in the bagger cover.
See Figure 12.
ASSEMBLY AND INSTALLATION
Figure 11
Figure 12
7.
Open Hood by pushing in on the rear, right-side tab with your right hand, as
shown in 1 of Figure 13, and lifting the cover with your left hand in the center
rear of the bagger cover, 2.
2
8.
Install the bag assemblies onto the bag support brackets by inserting the
front edge in first, as shown in Figure 14, and setting the back edge down
until it fits into the assembly.
1
11
1
Figure 13
2
Figure 14

Publicidad

loading