Munters ED36HE Manual De Mantenimiento página 9

ROUTINE 3
Suitable for EC52
fig.11
fig.12
fig.13
1. With the propeller at a complete standstill, open the
safety mesh on the shutter side.
2. Open the side cover plates.
3. Unthread two tie-rod with holes and unscrew bolts
and nuts which fix shutter closing springs.
4.A IF THE V-BELT HAS TO BE REPLACED:
a1. [IF WITH MOTOR MOUNTED ON TOP PANEL
– EC52 top] Remove the two shutter blades in
correspondence of the motor and then replace
the worn V-belt by letting it pass between the
conveyor and the propeller.
a2. [IF WITH MOTOR ON CENTRAL SUPPORT –
EC52 old] Remove the knurled brass pin by
using a pin brunch and small hammer to
disconnect the central shutter blade and the
centrifugal system.
b2. Remove the nut and the aluminum waterproof
distance piece.
c2. Remove
hexagonal axle by loosening the M8x20 screw.
d2. Remove the propeller - central pulley assembly
and replace the V-Belt.
e2. Fix the assembly on the central support.
4.B IF THE CENTRIFUGAL SYSTEM HAS TO BE
REPLACED:
a. Remove the knurled brass pin by using a pin
brunch and small hammer to disconnect the
central shutter blade and the centrifugal system.
b. Remove the central shutter blade and the ones
below and above.
c. Remove
hexagonal axle by loosening the M8x20 screw.
d. Insert the new centrifugal system.
9 | © Munters AB, 2018
the centrifugal system
the centrifugal system
from the
from the