Publicidad
Idiomas disponibles
Idiomas disponibles
Chute Handle
The direction
of snow throwing
corresponds
to the direction
of the chute opening.
Use the chute handle to turn the chute
assembly
in the direction
you wish to throw the snow.
Chute Knob
The distance
snow is thrown
can be adjusted
by either
raising
or lowering
the upper chute. Loosen the chute knob on the side
of the upper chute to adjust. Pivot the upper chute to desired
position,
and retighten
the chute knob.
ShavePlate
The shave plate maintains
contact
with pavement
as the snow
thrower
is propelled,
allowing
snow close to pavement's
surface
to be discharged.
Skid Shoes
Position the skid shoes based on surface conditions.
Adjust
upward
for hard-packed
snow. Adjust
downward
when
operating
on gravel or crushed
rock surfaces.
GasCap
Remove gas cap to add fuel. This unit runs on regular gas.
Oil Fill
Engine oil level can be checked and oil added through
the oil fill.
NOTE:The
engine is shipped
with oil in it. Check the oil level
before the first use and add if necessary, as specified
in the
separate
engine manual packed with your snow thrower.
Always
check the oil level prior to each use.
Choke
I11
The choke control
is found
on the rear of the engine and is
activated
by rotating
the knob clockwise.
Activating
the choke
control
closes the choke plate on the carburetor
and aids in
starting
the engine.
Primer
Pressing the primer forces fuel directly
into
the engine's
carburetor
to aid in cold-weather
starting.
PUSHFORA
k_COLD ENGiNE_
ThrottleControl
The throttle
control
is located
on the rear of the
engine. It regulates
the speed of the engine and
will shut offthe
engine
when moved into the STOP
position.
ChuteClean-OutTool
The clean-out
tool is conveniently
fastened to the
rear of the auger housing
with a mounting
clip.
When snow and ice collect in the chute assembly
during
operation,
use this tool to safely clean the
chute and the chute opening.
©
SECTION 4 --
CONTROLS AND FEATURES
11
Publicidad
