Troy-Bilt 300 Series Manual Del Operador página 7

Routing The DriveCable
1. Make sure that the drive cable is routed parallel to the left
upper handle, then across the top of the lower handle and
finally parallel to the right lower handle. See Fig. 3-3.
2. Three cable ties have been used to loosely tie the two
control cables to the lower handle. Two of these cable ties
are on each arm, and the third on the top cross bar of the
lower handle. Tighten these cable ties to secure the cable
to the lower handle. See Fig. 3-3.
Chute Clean-0utTool
The chute clean-out tool is fastened to the top of the auger
housing with a mounting clip and a cable tie at the factory. Cut
the cable tie before operating the snow thrower. See Fig. 3-5.
Auger Cable
Figure 3-3
Set-Up
ShearPins
A pair of replacement auger shear pins and bow tie cotter pins
are included with your snow thrower. See Fig. 3-4. Store them in
a safe place until needed.
I Figure 3-5 I
Tire Pressure
The proper inflation pressure is 20 psi. Check the tire pressure
periodically and maintain equal pressure in both tires at all
times. Excessive pressure (well above 20 psi) may cause the
wheel (tire/rim) assembly to burst with sufficient force to cause
serious injury. Do not over-inflate the tire. Use a manual pump or
portable electric tire inflator to prevent over-inflation.
NEVER USE AN AIR COMPRESSOR.
Gas& 0il Fill-Up
_ ARNING! Use extreme care when handling
gasoline. Gasoline is extremely flammable and the
vapors are explosive. Never fuel the machine
-- indoors or while the engine is hot or running.
Extinguish cigarettes, cigars, pipes and other
sources of ignition.
Service the engine with gasoline and oil as instructed in the
Tecumseh Engine Operator's Manual packed separately with
your snow thrower. Read instructions carefully.
NOTE:Your snow thrower is shipped with oil in the engine.
However, you MUST check the oil level before operating. Refer to
Tecumseh Engine Operator's Manual for detailed instructions.
Figure 3-4
SECTION 2 --
ASSEMBLY&
SET-UP
7