Briteq LDP-ACCUSPOT 7TC Manual De Instrucciones página 10

ENGLISH
"ShoW" Show Mode
Used to choose to select one of the preprogrammed multi channel shows
when used in standalone or master/slave mode.
 Press the MENU button until "ShoW" is shown on the display.
 Press the ENTER button to select.
 Use DOWN and UP buttons to select one of the preprogrammed shows:
 "Sh 1" all shows played in random mode.
 "Sh 1" to "Sh12"  12 different built-in shows.
 Except for the random show (Show 0) you will also be asked to select a
running speed for the static mode. With the UP/DOWN buttons you can
select "SP 1" (slow) to "SP 8" (fast).
 Once the right show is selected, press the ENTER button to confirm.
 Press the MENU button for about 2 seconds to return to running mode.
"ChaS" Color chase Mode
Used to choose to select one of the preprogrammed color fades when
used in standalone or master/slave mode. All projectors will always show
an identical output.
 Press the MENU button until "ChaS" is shown on the display.
 Press the ENTER button to select.
 Use DOWN and UP buttons to select one of the preprogrammed shows
 You will also be asked to select a running speed for the static mode. With the
UP/DOWN buttons you can select "SP 1" (slow) to "SP 8" (fast).
 Once the right show is selected, press the ENTER button to confirm.
 Press the MENU button for about 2 seconds to return to running mode.
"SOUn" Sound Mode
Used to choose the desired sound mode to trigger the shows.
 Press the MENU button until "SOUn" is shown on the display.
 Press the ENTER button to select.
 Use DOWN and UP button to select one of the available modes:
 " on " (sound mode ON)  the shows are triggered by the internal
microphone.
 " oFF" (sound mode OFF)  the shows are triggered by the speed
selected with the shows.
 Once the right mode is selected, press the ENTER button to confirm.
 Press the MENU button for about 2 seconds to return to running mode.
"SenS" Sound Sensitivity
Used to set the sensitivity of the internal microphone
 Press the MENU button until "SenS" is shown on the display.
 Press the ENTER button, the display starts blinking.
 Use DOWN and UP button to select a value between "0" (very low
sensitivity) and "100" (high sensitivity).
 Once the mode is selected, press the ENTER button save it.
To go back to the main menu without any change press the MENU button
shortly.
If you want to go back to normal running mode: press the MENU button for
about 2 seconds.
"Addr" DMX512 Address Setting
Used to set the start address in a DMX setup.
 Press the MENU button until "Addr" is shown on the display.
 Press the ENTER button to select.
 Use DOWN and UP buttons to change the DMX512 address.
 Once the correct address is shown on the display, press the ENTER button
to confirm.
 Press the MENU button for about 2 seconds to return to running mode.
BRITEQ
®
8/69
USER MANUAL
LDP-ACCUSPOT 7TC