Briteq LDP-ACCUSPOT 7TC Manual De Instrucciones página 5

ENGLISH
 The housing and the lenses must be replaced if they are visibly damaged.
 Please use the original packing when the device is to be transported.
 Due to safety reasons it is prohibited to make unauthorized modifications to the unit.
Important: Never look directly into the light source! Don't use the effect in the presence of persons suffering
from epilepsy.
DESCRIPTION:
1. Projector with hard plastic cover to protect the LEDs. The projector orientation can be seamlessly
adapted from horizontal position (beam in vertical position) to vertical position (beam in horizontal
position)
2. Handle to easily carry the projector. In certain cases it can also be used as a hanging bracket to fix the
projector in truss, using a mounting hook.
3. Knob used to fasten the projector (1) in any desired angle.
4. Ventilation holes: these must be free at any moment during operation and while charging the batteries.
5. ¼" Jack used to connect an optional JBS CA-8 controller.
6. Microphone, used to trigger the internal chases while used in standalone mode.
7. Mains input with IEC socket and integrated fuse holder, connect the supplied mains cable here.
8. Mains output with IEC socket: you can use a special IEC power cable to connect this output with the
mains input of the next LDP-ACCUSPOT for easier linking. (max 40 units can be linked)
9. DMX-output connector
10. DMX-input connector
11. ON/OFF switch for the projector. The charging circuit is still operational while the unit is switched off.
12. DMX LED: is lit when the unit receives a DMX-signal
13. SOUND LED: blinks to the rhythm of the music while the unit is in audio mode
14. MASTER / SLAVE LED: is lit when the unit is in master or slave mode
15. BATTERY CAPACITY LED: indicates roughly the level of the battery:
 LED lit: battery is 75% to 100% of its full capacity
 LED blinking slowly: battery is 25% to 75% of its full capacity
 LED blinking fast: battery is 5% to 25% of its full capacity. Once the capacity reaches 5%, the
projector output shuts down, charging is needed!
You can select the exact level of the battery also in the setup menu, see option "batt" in the setup menu.
16. MENU button: used to select the different menu items
17. DOWN button: to go back in the menu and to lower the values shown on the display.
18. UP button: to go up in the menu and to increase the values shown on the display.
19. ENTER button: used to confirm your choice.
20. DISPLAY shows the various menus and the selected functions.
21. WIRELESS W-DMX-module: optionally available module with special antenna that can be used for
wireless DMX-control of the projector. To reduce cost you can daisy chain the other projectors using a
normal DMX-cable.
22. CHARGING INDICATOR: color is red while the battery is charged, color turns green when the battery is
fully charged.
BRITEQ
®
3/69
USER MANUAL
LDP-ACCUSPOT 7TC