Operation Instructions - NORPOLE NPPAC12HKM Manual Del Usuario

OPERATING INSTRUCTIONS
CONTROLS
Swing Sleep
(3s Reset Filter)
a
a. Swing button (For models with auto swing feature): Used to initiate the Auto swing feature. When the
function is ON, press the SWING button to stop the louver at the desired angle.
b. Sleep / Filter button: Used to initiate the SLEEP/ECO operation.
NOTE: After 250 hours of operation, the filter indicator lights remind you to clean the Air Filter for
more efficient operation. Press this button for 3 seconds to cancel the reminder.
c. Timer button: Used to initiate the AUTO ON start time and AUTO OFF stop time program, use with
the + & - buttons. The timer on/off indicator light illuminates under the timer on/off settings.
d. Fan button: Controls the fan speed. Press to select the speed in four steps-LOW, MED, HIGH and
AUTO. The fan speed indicator light will show the setting.
e. Mode button: Selects the operating mode. Each time you press the button, a mode will change from
AUTO – COOL – DRY – FAN – HEAT. The mode indicator light indicates what mode is set.
f. Down (<) and Up (>) buttons: Used to adjust temperature settings in 1°F/1°C increments in a range
of 62°F/17°C to 86°F/30°C or the TIMER setting in a range of 0~24hrs.
g. NOTE: The control is capable of displaying temperature in Fahrenheit or Celsius. To change from F
to C, press and hold the Up and Down buttons at the same time for 3 seconds.
h. Power button: Used to turn the unit On or Off.
i. LED Display: Displays the set temperature in °F or °C and the Auto-timer settings. While on DRY
and FAN modes, it shows the room temperature.
Error Codes
• E1: Room temperature sensor error.
• E2: Evaporator temperature sensor error.
• E3: Condenser temperature sensor error.
• E4: Display panel communication error.
• E7: Zero-crossing malfunction.
Filter
On
Off
Timer
b c
Heat
Auto Auto
High Cool
Med Dry
Low Fan
Fan Mode
d e
Protection Code
• P1: Water tray is full.
15
Figure 10
h
Power
f g